I am trying to run a batch plot. Whether it's a PDF or DWF it is only batching the drawing I have open, not any that I add from file (that aren't open). Anyone know how to correct this?
How are you trying to run the batch plot? Are you using the Publish command?
If you use the Publish command and the layouts are not initialized or the page setup is not adjusted properly, the batch plot may not work as expected.
Make sure that you see the Status = No errors and that there is no exclamation mark close to the printer icon under Page Setup.
Hope this helps,
Product Support Specialist
Access a broad range of knowledge to help get the most out of your products and services.