AutoCAD 2010/2011/2012

Reply
Member
sciberras
Posts: 3
Registered: ‎07-16-2007
Message 1 of 1 (204 Views)

AMEP2010 Electrical Device

204 Views, 0 Replies
10-26-2012 04:54 AM

First of all apologies for my last post. Looks as though Navis isnt the problem.

 

When i created devices in the past i would make the 2D block on layer 0 and bylayer. The 3D block would be also on layer 0 but forced to the colours that i wanted to see.

 

We have upgraded to 2010 and when the devices are viewed in isometric they all come out the same colour as the layer they are inserted on.

 

The only exception to this is when a block is in a block ( i know.... not good practice) but was discovered when a draftsman made a mistake.

 

Can anybody help me? Have hundreds of devices and will take too long to remake them.

 

Cheers

 

Ben

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.