How can I correct my the Display the UCS icon, everythime I chaged ucs it shows upside down and i have to maually click the 'view icon so it goes to the origin point on the screen (0,0,0).
I tried to correct it with the View manager but it doest allow me.
I'm not sure to understand your issue, but it may help to look to the sysvars
UCSICON (>>>details<<<) .... or
HTH, - alfred -
I meant that everytime I change views (plan, A, B, C,D eleveations) the XY cordinate showa upside down. So I have to establish the coordinates system to XY plane parallel to the screen.
See image attached...
>> [...] everytime I change views [...]
And have you tried/read about UCSFOLLOW or not?
- alfred -
can you create a new drawing, make some 3D-object (that is not symmetric) and then change your views ... same problem? If yes then upload the drawing + copy the content of your command-line so we can see what commands you started to change your view.
- alfred -
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!