Solved! by ossmo02. See the answer in context.
So far the only option I have seen is to Wblock it to a new drawing. If it was 1 print I could do it for you.
if it was as easy is that do you think i would have posted on the forum.
it has unload or reload, and whichever one you select it does nothing as its not referenced to anything.
any more suggestions???
yeah, do you read what i put there or not, When i press on unload it doesnt go anywhere it is still there,
IT WILL NOT UNLOAD no matter how different it is, it is unreferenced there is no jpeg there, i want to remove it from the x-ref manager as when i open the drawing it is looking for an image that isnt there.
DO YOU UNDERSTAND, DID YOU LOOK AT THE IMAGE I ATTACHED
It sounds like there may be an error in the OP's install if detach is not available.
You should see this page;
it may help your situation
thanks for your reply, i have looked at that article you provided and tried the command, but still nothing, i have attached some images for you to see.
That might be a solution for full blown autocad where as i am looking for LT solution.
Access a broad range of knowledge to help get the most out of your products and services.