AutoCAD 2007/2008/2009

Reply
Active Contributor
donz67z
Posts: 33
Registered: ‎01-13-2009
Message 1 of 3 (109 Views)

Plotting Area

109 Views, 2 Replies
06-08-2012 12:55 PM

When I plot and change the X/Y it move the drawing but it also shows my drawing being cut off about a half inch(1cm) from the right edge but it allows my drawing to get very close to the left edge without cutting off the drawing. how do I center the plotting area? Using "center the plot" doesnt solve the problem.

 

thanks guys

 

don

*Expert Elite*
Alfred.NESWADBA
Posts: 8,963
Registered: ‎06-29-2007
Message 2 of 3 (107 Views)

Re: Plotting Area

06-08-2012 01:38 PM in reply to: donz67z

Hi,

 

to make it easier to verify what you mean and what your settings are:

  • set the plotter-driver to a PDF-one
  • upload a screenshot of the plot-dialog (after you have set the values)
  • plot to PDF and upload this PDF
  • save and upload a drawing

....so we see all your settings and what your X-movement does what you don't like to.

 

- alfred -

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------
*Expert Elite*
scot-65
Posts: 2,156
Registered: ‎12-11-2003
Message 3 of 3 (100 Views)

Re: Plotting Area

06-08-2012 03:13 PM in reply to: donz67z

PLOTOFFSET = 1 ???

 

Does "Plot Preview" display this problem?

Are the margins uneven only on the hard copy?

Are you selecting the "Expanded" sheet size?

 

What is opposite to TMI???

 

Scot-65
Dyslexia is a permanent physical disability that cannot be seen.
Introverts is proof that there is indeed intelligent life on this planet.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.