AutoCAD 2007/2008/2009

AutoCAD 2007/2008/2009

Reply
Contributor
JeffWVULT
Posts: 21
Registered: ‎01-22-2008
Message 11 of 14 (242 Views)

Re: Need help drawing line with radius

01-02-2013 06:25 PM in reply to: scot-65

Moshe and Scot, thanks so much. Both of those methods worked for me individually!   

*Expert Elite*
scot-65
Posts: 2,189
Registered: ‎12-11-2003
Message 12 of 14 (230 Views)

Re: Need help drawing line with radius

01-03-2013 03:13 PM in reply to: JeffWVULT

Drafting this was automatic as I was formally trained as a "board" person

at the time the word "computer" was defined as a machine that took up the

space of an average sized bedroom and stored data on a magnetic tape.

 

It took a minute to write these steps sequentially so one can understand.

 

PUT AWAY THAT CALCULATOR!

 

:-)

 

Scot-65
Dyslexia is a permanent physical disability that cannot be seen.
Introverts is proof that there is indeed intelligent life on this planet.
Distinguished Mentor
steve216586
Posts: 946
Registered: ‎07-10-2007
Message 13 of 14 (217 Views)

Re: Need help drawing line with radius

01-07-2013 08:38 AM in reply to: JeffWVULT

WOW, guys you really do things the hard way!

 

Easy is like the following:

 

Start Pline command: 

Draw a vertical line from the top at the desired distance.  (It isn't given so I used 3'):

Change to arc.  Use command line entry - @6,-6 "enter":

then Command line entry again - @5,-5 "enter":

Change to line and complete the vertical line to finish point.  (Again I used 3')

 

See attached pic.

 

One command and three clicks.  Simple!

*Expert Elite*
scot-65
Posts: 2,189
Registered: ‎12-11-2003
Message 14 of 14 (205 Views)

Re: Need help drawing line with radius

01-07-2013 03:37 PM in reply to: steve216586

Good observation / solution Steve.

I went with the pretense that the two vertical lines were existing and the OP wanted

to connect these two with arcs of specified radius.

Your solution showed the tangent of the two arcs at the quadrants, which was not

the desired look on the OP's smart phone pic (the vertical lines were closer together

than what you show)...

 

???

 

Scot-65
Dyslexia is a permanent physical disability that cannot be seen.
Introverts is proof that there is indeed intelligent life on this planet.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.