Distance command (DI) not showing correct measurement in the bottom left hand corner in autocad 2009. Does anyone know how to get that to show the correct dimension when I DI a line.
Solved! Go to Solution.
Solved! by Appleroofing. See the answer in context.
I just clicked on the drawing coordinates and clicked it back on and know it seems to be working fine.
>> Distance command (DI) not showing correct measurement
Can you show us an example? Upload a drawing and tell us what you did and what AutoCAD reported. We haven't seen what your drawing contains (especially 2D or 3D), what objectsnaps you had active, what AutoCAD told you how long the line is and what the property-window tells you about the line-length, if you were in modelspace or layout/paperspace ....
At least we don't have enough info's to answer your question.
- alfred -
It is the measurements below the command prompt in the left hand bottom corner. In paper space it works fine, but in model space the measurements are all over the place. It worked fine before.
>> but in model space the measurements are all over the place.
In the lower left corner of the status-line there is shown a coordinate of where your are, that has nothing to do with the length of the line or the result of a distance-command.
Maybe it's a help if you look to the WCS/UCS: have you created a user-defined coordinate system (UCS)? If so, the coords shown in this lower-left corner area show you the UCS-coords, not the ones from the world coordinate system. What happens if you switch to WCS using command _UCS ==> option _WORLD?
Again: we don't see your AutoCAD/your drawing, so we don't know what coords AutoCAD shows you and where your cursor is.
- alfred -
I`m having the exact same problem.
As you can see in the 2 example jpg`s when i simply use the AutoCAD command distance for 2 lines offset 1200 apart, it displays 1200. GREAT.
BUT when i offest a line on a 45 degree angle at say 1500 the distance command displays 1060.7.
BUT when you use Angular Dimension it dimension correctly showing 1500.
Any advice please.
Sorry, false alarm.
Silly me simply had 2 lines of the command line showing.
I`ve since stratched it make 3 lines.
Now i see the Distance, Angle, etc..
It was always there!!!
thanks in advance.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!