I started using the data extraction wizard for material cut lengths. I ran into a issue where it is not combining like values, even when the "combine identical rows" box is checked. I am using architectural units with 1/16" precision. The first time I had this problem when I switched the units to decimal and precision to its most accurate state (.00000000) and noticed the two different lines (even though they were copied) were off by .00000003" I changed the lengths of the lines and they combined into one row in the spreadsheet. However today, the lines are IDENTICAL and they are not combining. What can I do to change the combining precision to match equal lengths to the 1/16", even if they are, lets say 1/64" off?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!