AutoCAD 2007/2008/2009

Reply
Member
ryant35
Posts: 3
Registered: ‎03-06-2009
Message 1 of 3 (160 Views)

Block Insert & Edit Attributes

160 Views, 2 Replies
03-23-2009 09:19 AM
I have AutoCAD 2009 installed on 2 different PC's at 2 different locations. On at home when I insert a block with an attribute it asks for the value in the command line like the previous versions.

At work it opens an 'Edit Attributes' window in the middle of the screen and it slows me down because I can't hit enter or right click to close it. I attached a screen shot.

Does anyone know how to change this setting? I thought I set up the programs the same at both locations but somehow at home it works like I want it to.
*R.K. McSwain
Message 2 of 3 (160 Views)

Re: Block Insert & Edit Attributes

03-23-2009 09:46 AM in reply to: ryant35
ryant35 wrote:
> I have AutoCAD 2009 installed on 2 different PC's at 2 different
> locations. On at home when I insert a block with an attribute it asks
> for the value in the command line like the previous versions. At work it
> opens an 'Edit Attributes' window in the middle of the screen and it
> slows me down because I can't hit enter or right click to close it. I
> attached a screen shot. Does anyone know how to change this setting?

Check out ATTDIA.



--
R.K. McSwain
http://cadpanacea.com
Member
ryant35
Posts: 3
Registered: ‎03-06-2009
Message 3 of 3 (160 Views)

Re: Block Insert & Edit Attributes

03-23-2009 09:49 AM in reply to: ryant35
That was it! Thank you very much.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.