AutoCAD 2004/2005/2006

New Member
Posts: 1
Registered: ‎01-12-2012
Message 1 of 1 (326 Views)

Trim/Extend crashes Autocad

326 Views, 0 Replies
01-12-2012 12:08 PM

When using the trim or extend command, sometimes it will crash autocad.  It only happens when I trim or exted in "smart" or "dynamic: mode - enter trim/extend command, hit return twice, then pick the line to trim/extend.  It does not happen consistantly, and I cannot intentionally recreate it.  It doesn't matter if it's a pline, or if there are blocks, xrefs, groups, or just 2 lines involved.  I'm using Autocad 2004 on a new Dell  I3 chip, 3G ram, and working in 2D, basic stuff, no 'heavy lifting' - (residential house plans).  Any thoughts?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.