AutoCAD 2004/2005/2006

Posts: 20
Registered: ‎04-30-2009
Message 11 of 11 (137 Views)

Re: offset using 'cal

09-07-2012 08:34 AM in reply to: JDMather

I noticed this to, both OFFSET and AMOFFSET are the same in 2013, major pain in the ****.

I did not have this problem in 2012, I was able to use both CAL and 'CAL in the OFFSET command.



Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.