AutoCAD 2000/2000i/2002 Archive (Read Only)
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Reply
Message 1 of 6
jaki_collison
184 Views, 5 Replies

Polyline snaps

Having drawn a polyline and wish to snap to the mid point of a segment of the polyline, I only get the actual mid point of the polyline. How do I change this to get what i want?
5 REPLIES 5
Message 2 of 6
Anonymous
in reply to: jaki_collison

Are you sure your Pline portion is a segment?

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--
Message 3 of 6

Dean,

I converted lines into a polyline, and it is the midpoint of one of these individual lines I want.
Message 4 of 6
Anonymous
in reply to: jaki_collison

Cannot reproduce it: can you post a sample file?

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--
Message 5 of 6
rhodri.lea
in reply to: jaki_collison

I get the same problem it only seems to happen with polylines that include arc segments. However it seems to be erratic. Sometimes it will find the end-points but not the mid-points or it will only snap to one end of the segment but not the other. Any ideas?
Message 6 of 6
rhodri.lea
in reply to: jaki_collison

I get the same problem it only seems to happen with polylines that include arc segments. However it seems to be erratic. Sometimes it will find the end-points but not the mid-points or it will only snap to one end of the segment but not the other. Any ideas?

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report