Active Member
Posts: 7
Registered: ‎02-22-2010
Message 1 of 2 (584 Views)

partial load on dwg does not work anymore

584 Views, 1 Replies
07-19-2010 12:27 AM

have been using one dwg as modelspace basis, in it created different views and saved it with option index. perhaps about a couple of months working with it (happily) and partially loading it, this doesn't work anymore. upon open i still get the drop down list with partial open and read-only but only the latter actually works, partial open simply appears to fully open, no dialog box anymore for specifying the partial and the full dwg gets loaded. the dwg is just over 4,000kb with 1 empty paperspace sheet, did a recovery - nothing found. any ideas?

Active Contributor
Posts: 38
Registered: ‎04-19-2010
Message 2 of 2 (564 Views)

Re: partial load on dwg does not work anymore

08-06-2010 03:29 AM in reply to: felixhoepke7855

i use mdt 2009 and i have the same problem, the parcial open dont work.

My drawing have many xref, i go to manage xref and unload same parts

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.