Alias General Discussion

Alias General Discussion

Reply
New Member
RSQuantus
Posts: 1
Registered: ‎12-26-2011
Message 1 of 1 (185 Views)

Multi-Surface Draft tool - Surface created is twisted 180 degrees.

185 Views, 0 Replies
12-26-2011 11:57 AM

New to Alias. At the 7min mark in Part4 Video2 of Autodesk WikiHelp Vacuum Tutorial, "Enclose the Shapes".

 

After picking the QbjectEdit - QueryEdit tool, then selecting the small front draft surface, and finally picking the back profile curve and clicking Recalc, the surface that is created is twisted 180 degrees. The surface should be created in the same direction as the small front draft surface.  I do not know what it is that I am doing wrong. Is it one of my settings?  Please see my attached pic below the links.

 

Link to Video: 

 http://wikihelp.autodesk.com/Alias/enu/2012/Help/0109-Tutorial109/0110-Learning110/0117-Learning117/...

         (At the 7min mark in Part4 Video2 of Autodesk WikiHelp Vacuum Tutorial, "Enclose the Shapes".) 

Link to Instructions:

 http://wikihelp.autodesk.com/Alias/enu/2012/Help/0109-Tutorial109/0110-Learning110/0114-Part_4%3a_11...

         (Go down to Sub-Catergory: Intersect and trim the surfaces)

 

Your help would be greatly appreciated.

 

Thanks in advance. 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!