Multi-Surface Draft tool - Surface created is twisted 180 degrees.

[RSQuantus]

New to Alias. At the 7min mark in Part4 Video2 of Autodesk WikiHelp Vacuum Tutorial, "Enclose the Shapes".

After picking the QbjectEdit - QueryEdit tool, then selecting the small front draft surface, and finally picking the back profile curve and clicking Recalc, the surface that is created is twisted 180 degrees. The surface should be created in the same direction as the small front draft surface.  I do not know what it is that I am doing wrong. Is it one of my settings?  Please see my attached pic below the links.

Link to Video: 

 http://wikihelp.autodesk.com/Alias/enu/2012/Help/0109-Tutorial109/0110-Learning110/0117-Learning117/...

         (At the 7min mark in Part4 Video2 of Autodesk WikiHelp Vacuum Tutorial, "Enclose the Shapes".) 

Link to Instructions:

 http://wikihelp.autodesk.com/Alias/enu/2012/Help/0109-Tutorial109/0110-Learning110/0114-Part_4%3a_11...

         (Go down to Sub-Catergory: Intersect and trim the surfaces)

Your help would be greatly appreciated.

Thanks in advance.