Alias General Discussion

Alias General Discussion

Reply
New Member
nitromike
Posts: 1
Registered: ‎03-02-2011
Message 1 of 2 (186 Views)

good pc for alias modeling

186 Views, 1 Replies
05-22-2012 09:52 AM

hi there! I want to buy a decent pc for alias . I'll built it myself with afriend but I have no clue what specs should be good for a decent windows pc since I've been a mac user for years but I want to go back to the pc. any suggestions concerning the ram, graphics card, vram etc? maybe this thread would be helpful for a lot of users! I use a pretty nice dell at work but it always slows down quite a bit when the anti aliasing is in effect. especially with the center pivot tool ?!??

as I said I'm a total noob concerning the pc so any suggestions are very very welcome!

best wishes, mike 

 

Distinguished Contributor
donest
Posts: 126
Registered: ‎04-27-2009
Message 2 of 2 (155 Views)

Re: good pc for alias modeling

06-21-2012 10:28 AM in reply to: nitromike

You should check the hardware qualification chart (a good place to start). To avoid any video issues later, I would recommend one of the Quadro video cards. Whatever you can afford for Ram...at least 4 gigs. The more, the better. It doesn't seem to matter much to a lot of users, but I also check out the Frontside Bus Speed (FSB) of the motherboard.  

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.