Alias General Discussion

Alias General Discussion

Reply
Valued Contributor
JohnDixon8251
Posts: 60
Registered: ‎01-26-2010
Message 11 of 13 (131 Views)

Re: Curve Snap tolerance issue - does not really snap onto curve but next to it

10-02-2012 03:51 PM in reply to: cekuhnen

That is correct, what you are doing is fine. And, interestingly enough, your screen shot is now appearing in the first post.

Valued Mentor
ravenzep
Posts: 359
Registered: ‎10-05-2009
Message 12 of 13 (124 Views)

Re: Curve Snap tolerance issue - does not really snap onto curve but next to it

10-24-2012 02:09 AM in reply to: JohnDixon8251

SET DRAW PRECISION to something like 0.85.

That should do it, or you have a gfx hardware issue.

Contributor
nicolas.caquelin
Posts: 20
Registered: ‎10-18-2009
Message 13 of 13 (85 Views)

Re: Curve Snap tolerance issue - does not really snap onto curve but next to it

02-26-2013 01:12 PM in reply to: ravenzep

I think also about the Draw Precision value issue, by default Quality Draw Precision = 0.5

This is too low if you are working in Class A with a single span surfaces / curves, as the previous post said try to increase the value if your computer works.

But take care about the value, if you check the maximum is 1 but after many investigations please remind about the "exponentiel" value from 0 to 1, also if you put 1 the most of the time 90% it works well... But sometime you will feel your model move slowly and block looks too big ! ! ! My recommendation is to put maximum 0.9 for a nice result.

 

Regards,

Nicolas Caquelin

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.