Alias General Discussion

Alias General Discussion

Reply
New Member
ben_fullerton89
Posts: 1
Registered: ‎08-14-2012
Message 1 of 3 (986 Views)

Alias Tutorial Courseware files missing?

986 Views, 2 Replies
08-14-2012 12:45 PM

Hi

 

Within the Alias Help document there is an instruction to follow this link:

 

"Download the courseware files from the Alias Design Community Web site http://aliasdesign.autodesk.com."

 

in order to download the courseware files needed for the tutorials. 

 

The problem is that link now takes me to the Mosaic.Project page, where there is no sight of what i am looking for. Also any previous discussions and answers are all from a few years ago and i end up in the same place each time.

 

basically can someone please tell me where i can now find the courseware files for the alias tutorials. 

 

thanks in advance.

 

ben

Employee
rangt
Posts: 21
Registered: ‎06-17-2008
Message 2 of 3 (974 Views)

Re: Alias Tutorial Courseware files missing?

08-15-2012 07:07 AM in reply to: ben_fullerton89

Hello,

Apparently there were problems with lost content during the transfer to Mosaic.  I believe you're looking for this legacy content which we've reposted to the wiki:

http://wikihelp.autodesk.com/Alias/enu/2013/Help/1869-Tutorial1869/Legacy_Alias_Tutorials

 

Let me know if this is not what you were looking for.



Tom Rang
Software Quality Assurance Manager
DLS – Design, Lifecycle, & Simulation
Autodesk, Inc.

New Member
wilsonjonw
Posts: 1
Registered: ‎01-16-2013
Message 3 of 3 (772 Views)

Re: Alias Tutorial Courseware files missing?

01-17-2013 11:28 AM in reply to: rangt

Thank you,
I've been looking around for the content alias attempts to send me to, but I just couldn't find it! And yet... This is where they are located on the 'new' wiki, true.  But when I attempt to access them, i get a return error.

"Bad Request (Name contains invalid characters)"
As someone who'se trying to learn alias, even though it isn't ofered at my school, (Rhino is, though, due to financial reasons,) this makes it very difficult.  Is there something I'm doing wrong?
thanks,
Jonathan.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.