Community
Alias Forum
Welcome to Autodesk’s Alias Forums. Share your knowledge, ask questions, and explore popular Alias topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

How to Ace K Transition Surfaces?

3 REPLIES 3
Reply
Message 1 of 4
paulofern
774 Views, 3 Replies

How to Ace K Transition Surfaces?

Hi, Guys....

 

Please, Is there anybody out there that could help in master k transition corners in G2? How can I fillet that model?

k Transition Fillet.jpg

 

The wire model is at  http://s000.tinyupload.com/?file_id=00851448007744138826

 

 

Thanks for You help

3 REPLIES 3
Message 2 of 4
m.panas
in reply to: paulofern

It really depends on how you want the light to flow. There are at least 4 acceptable solutions.

 

I think this could be a good one, but it might be tricky. You have to try a few to know which one works best.

Message 3 of 4
duaxiong
in reply to: paulofern

This is what I would do:  

 

Notice that I changed the sizes of some of your fillets to allow for more natural transitions.

 

 

The small three-sided surface is a trimmed patch.

 

K.jpg

Message 4 of 4
systembolaget
in reply to: paulofern

Another solution, from single span surfaces, particularly when the angle between the two "flaps" is narrower and the two "arms" (fillets) of the K are running into each other in a pointed fashion.

 

Bildschirmfoto 2017-07-19 um 16.51.35.png

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report