Visual LISP, AutoLISP and General Customization

Reply
Distinguished Contributor
Posts: 213
Registered: ‎07-14-2004
Message 1 of 4 (82 Views)

Put block elements back in original position

82 Views, 3 Replies
03-26-2009 03:05 PM
I have lots of the same block with attributes. Someone has moved the elements (the attributes) all around using grips and now it is a big mess. Is there any command to make the block attributes revert back to the original position? This drawing comes from a consulant so I can't get anything elce.
Thanks
Active Contributor
Posts: 35
Registered: ‎03-17-2009
Message 2 of 4 (82 Views)

Re: Put block elements back in original position

03-27-2009 12:06 AM in reply to: erickson123
look at

http://discussion.autodesk.com/forums/thread.jspa?threadID=721149&tstart=15
Active Member
Posts: 8
Registered: ‎07-10-2008
Message 3 of 4 (82 Views)

Re: Put block elements back in original position

03-29-2009 05:49 PM in reply to: erickson123
Try using either ATTSYNC or BATTMAN.
Distinguished Contributor
Posts: 213
Registered: ‎07-14-2004
Message 4 of 4 (82 Views)

Re: Put block elements back in original position

03-30-2009 07:15 AM in reply to: erickson123
Thanks,

I ended up using attredef which worked-

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community