Visual LISP, AutoLISP and General Customization
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Program for Cross Section By Manual Input.

3 REPLIES 3
Reply
Message 1 of 4
animkundu
2007 Views, 3 Replies

Program for Cross Section By Manual Input.

Is it possible to write a program for cross section by manual input of data like below. Objective is to draw a cross section with gridlines and labels of section data and datum value.

 

Program will ask for :

 

Datum value ?

Grid line spacing ?

 

Datas are :

Section Left

Chainage  5     Section value : 12.5
                10                            13.5
                 20                            5
                 23.7                         3

                and so on.....

 

Section Right

Chainage  5     Section value : 8
                10                    13.5
                20.5                  15
                25                      3

                30                      14

               and so on.....

 

Please Help.

3 REPLIES 3
Message 2 of 4
3wood
in reply to: animkundu

Can you upload a completed drawing so we can imagine what it looks like?

Message 3 of 4
alanjt_
in reply to: animkundu

Seems doable, but not a simple endeavor to take on, unless I'm not fully understanding.

Message 4 of 4
animkundu
in reply to: 3wood

Thanks for your reply.

 

 A sample drawing is attached.

 

Regards

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost