Erick,
I don't know if the attached file will help or not, but it may give you some
ideas. Note the use of Groups, Layers, and a 0 MLinescale for the center
mline.
Curves could be problematical, but perhaps could be approximated with enough
vertices.
hth,
David Kozina
wrote in message
news:5512522@discussion.autodesk.com...
Is there a way to create a linetype that can have more than one line. For
example, if I'm drawing a curb and gutter, could I have a linetype that
would be the center (face of curb), and at the same time draw/show the back
of curb and edge of pavement? If so, how could I go about doing this? I've
tried using the multi line option, but it does not put the lines on the
corresponding layers. meaning, the back of curb on a boc layer, etc. If
anybody has any thoughs on this, I would appreciate it. Thanks.
Erick Garcia-Salas