While renaming or viewing with DWG viewer Vault Access by default to C:/temp I wanted to change it to some other location. Is it Possible to do the change I am currentley using Vault Basic 2012.
check following wiki page please
Thanks for your feedback, please restore to the orignial one to make sure the application run well first. I tried in 2012 Vault, the trick works fine to me, You may refer to attached screenshot & copy for the reference.
(Note, the copy include the change of temp folder only, other sections from a fresh installation, if you simplely replace yours with it, you may lost your other settings.)
btw, Andy also replied your comments in wiki page, hope both helpful.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.