Chnge C:/temp to another location in Vault

[tanveer4m]

While renaming or viewing with DWG viewer Vault Access by default to C:/temp I wanted to change it to some other location. Is it Possible to do the change I am currentley using Vault Basic 2012.

[yuhui.zhang]

check following wiki page please

http://wikihelp.autodesk.com/Vault/enu/Community/Tips_and_Tricks/Changing_the_TEMP_Location

[tanveer4m]

After i modify Connectivity.Vault.exe.Config file vault 2012 is unable to run -- Thanks & Regards Tanveer

[yuhui.zhang]

Thanks for your feedback, please restore to the orignial one to make sure the application run well first. I tried in 2012 Vault, the trick works fine to me, You may refer to attached screenshot & copy for the reference.

(Note, the copy include the change of temp folder only, other sections from a fresh installation, if you simplely replace yours with it, you may lost your other settings.)

btw, Andy also replied your comments in wiki page, hope both helpful.

[tanveer4m]

Thanks for the reply.

All of these changes in that file doesn't effect in my vault.