Vault General Discussion

Reply
Distinguished Contributor
wseaston
Posts: 204
Registered: ‎03-04-2009
Message 1 of 2 (101 Views)

Checking in drawings

101 Views, 1 Replies
10-16-2009 12:34 AM
When I have completed a design (all assemblies, parts, drawings, etc) I open the top level GA drawing in inventor. I then select the vault tab and use the check in function.

This checks all the parts and assemblies into vault but leaves behind all the part drawings??

How can I check in all related content.

I am using the single project approach so I don't think I can use the "check in entire project" approach as this would try checking in designs which have already been added to vault?


Thanks
*Adam Luttenbacher \(Autodesk\)
Message 2 of 2 (101 Views)

Re: Checking in drawings

10-16-2009 06:03 AM in reply to: wseaston
The 'Check In Project' command will add the entire project to the Vault. If
the data is added to the Vault already then it will not attempt to add it
again (assuming your project is mapped correctly). Alternatively you can use
the Autoloader.

Regards,
Adam

"wseaston" wrote in message news:6272663@discussion.autodesk.com...
When I have completed a design (all assemblies, parts, drawings, etc) I open
the top level GA drawing in inventor. I then select the vault tab and use
the check in function.

This checks all the parts and assemblies into vault but leaves behind all
the part drawings??

How can I check in all related content.

I am using the single project approach so I don't think I can use the "check
in entire project" approach as this would try checking in designs which have
already been added to vault?


Thanks

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
New button for Platinum & Gold Subscription customers
Gold & Platinum Subscription customers can alert Autodesk if they require assistance with their forum post

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community