Utility Design General Discussion

Reply
Contributor
EL-Designer
Posts: 12
Registered: ‎05-25-2012
Message 1 of 2 (1,074 Views)

Standard

1074 Views, 1 Replies
05-25-2012 10:50 AM

I am new with this software and haven't tried it yet. I want to know if overhead's or under ground's Standard cover any specefic areas? is there any way to add specefic municipal standards?

Thank you

 

Active Contributor
jpab
Posts: 37
Registered: ‎10-02-2008
Message 2 of 2 (1,062 Views)

Re: Standard

05-27-2012 07:58 AM in reply to: EL-Designer

Hello,

The standard shipping version of AUD comes with the RUS Standards for overhead and underground engineering as well as material ordering for both. However since every utility is different and has their own standards AUD is configurable to almost any standard for both Engineering and Material ordering for overhead and underground.

A side note: The engineering values for the wires used in the shipping version came directly from either Alcan or Southwire so almost every utility should be able to use them as is. (all the utility would have to do is change the assembly name to match their standard)

 

if you want more information about AUD you can contact Linda Viet

Jim Bower

 

Linda Veit

lindaveit@spatialnet.net

www.spatialnet.net

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New Utility Design Category!

The Utility Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community