Utility Design General

Reply
Contributor
Posts: 11
Registered: ‎12-17-2008
Message 1 of 2 (1,402 Views)

Line Labeling

1402 Views, 1 Replies
12-10-2009 01:01 PM
When I label a conductor the information is attached to and stored with the line but it does not show up on the screen unless invoked by the "View Facility Information" button. Is there anyway to have the condictor size show up on the drawing? I need all conductors labeled on the screen so they can be plotted with the drawings.

Thanks in advance for any help!

Shawn
Heber Power
Active Contributor
Posts: 36
Registered: ‎10-02-2008
Message 2 of 2 (1,402 Views)

Re: Line Labeling

03-11-2010 02:23 PM in reply to: heberpower
Shawn,
have you tried and used the UDSCALLOUTcommand?
this command will insert a block with attributes anywhere on the dwg and it can be set (created) with the descrpition of the selected object and or other values.

Jim bower
Spatial Network Solutions

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New Utility Design Category!

The Utility Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community