Utility Design General Discussion

Distinguished Contributor
Posts: 904
Registered: ‎09-29-2005
Message 1 of 4 (237 Views)


237 Views, 3 Replies
02-10-2014 09:22 PM

How can we make duct bank show in the attached image.


Electronics Engineer

Pind Saudi Arabia

Posts: 17
Registered: ‎06-10-2008
Message 2 of 4 (126 Views)

Re: Duct

04-23-2014 08:13 AM in reply to: kulfi

The example image contains what appear to be many telecom and electric ducts. To model this in AUD you need to create 3D Model and Detail blocks for corresponding Segment and structure models. The blocks should be defined with ports defining the offsets/locations of each duct.


To create instances of the model you will need to setup Feature Library or CUI macros which allow the entire collection of ducts (and contained conductors and cables) to be drawn at once, or to use other commands such as AUDADDTOSEGMENT to add them individually to the same segment in the design.


Active Member
Posts: 7
Registered: ‎11-13-2006
Message 3 of 4 (121 Views)

Re: Duct

04-23-2014 09:13 PM in reply to: dave.w

Please can you show me one practical example so it is easier for me to understand.


Posts: 17
Registered: ‎06-10-2008
Message 4 of 4 (110 Views)

Re: Duct

04-24-2014 09:08 AM in reply to: NaderAzem2534

There should be some examples and details concerning configuration of this in the whitepaper entitled "Detail and 3D Model Creation for Trench and Structures". The whitepapers are accessible on Subscription Center.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New Utility Design Category!

The Utility Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community