Topobase

Reply
Active Contributor
Posts: 40
Registered: ‎09-18-2007
Message 1 of 1 (1,077 Views)

Data Check for backward connectivity of a feature

1077 Views, 0 Replies
01-05-2011 08:48 AM

Has anyone written a data check that will use the directional connectivity of a point and a line.  I have lines that were drawn in the wrong direction that I need to reverse.  I can get all of them checked but would like to wittle the set down from showing all 44000+ to just the ones that are drawn incorrectly.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community