Hello Moldflow Team.
There are several posts for the topic VENTING.
I think it is time to re-design the complete venting analysis.
1. In moldflow, it is a lot of work to create a venting along a split line.
In other simulation programs, it is much easear to implement venting areas. There you can select a edge on 3D body or a group of nodes.
So you do not have select each node / node by node.
2. put more informations in log file.
for example:
- venting pressure each time step
- for the warning message *306128* (air speed in the vent .... super sonic...) please include the node number in log file for the venting location this happens.
- if there is an increasing of the melt temperature in cause of high venting pressure, please include also the element number to locate the hot spot.
- Diesel effect ( https://forums.autodesk.com/t5/moldflow-ideas/new-result-plot-quot-diesel-effect-quot/idi-p/7002567)
.......
If somebody else have other ideas to the topic VENTING please post your comment!
Thanks to all
Regards
Lothar