Hello,
Settings: USL Code Combinations, Panel cut Detailed, Mxx, Direction x, layer absolute max
How I see absolute max (-55) in panel cut?
Please see attachments
Thanks
Solved! Go to Solution.
Solved by Rafacascudo. Go to Solution.
here
Rafael Medeiros
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Thanks (I saw that in your tread about moving loads on inclined slabs), but this isn’t the absolute maximum, this is either ULS+ or ULS -.
I need to see in my panels cuts what is the maximum of envelopes
Thanks a lot
If this is not what you need , I don´t really understand your question.
Rafael Medeiros
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
With the options you proposed I can see either the maximum positive or the maximum negative, but not the two au same time.
I was expected to see max absolute in the ULS and SLS code combination
Please see attachments
Thanks
I don´t think it is possible for panel cuts. Read posts from Artur on that incline slab thread ( http://forums.autodesk.com/t5/robot-structural-analysis/moving-load-on-inclined-slab/td-p/5397801) .
It´s on wish list.
Rafael Medeiros
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.