Discussion Groups

Simulation Moldflow Insight

Reply
Contributor
p.hammer
Posts: 18
Registered: ‎03-14-2013

map heating results of part insert to moldflow?

206 Views, 3 Replies
04-22-2014 03:30 AM

Hello, 

 

I did a heating simulation in CFD for a part insert.

 

Now I would like to map these results as starting temperature for a moldflow analysis.

 

Is this possible?

 

Philipp

Please use plain text.
Mentor
madhukeshwart
Posts: 263
Registered: ‎03-18-2009

Re: map heating results of part insert to moldflow?

05-11-2014 10:03 AM in reply to: p.hammer

At present it is not available... But  

 

If you have pre-heat temperature.. you can assign one value of temperature to insert. But cant map different temperature for each element 

Madhukeshwar Talwar
FIAT-CHRYSLER ATC, Chennai
mail: madhukeshwart@gmail.com
09600060862
======================================
Please use . Accept as Solution and Give Kudos as appropriate to further enhance these forums. Thank you! .....
Please use plain text.
Active Contributor
phammer
Posts: 29
Registered: ‎07-29-2011

Re: map heating results of part insert to moldflow?

05-11-2014 11:13 PM in reply to: madhukeshwart

HI everybody, 

 

answer I got from support was interesting.

 

Only workaround they had was to split the insert in several bodies and assing different starting temperature. 

 

Greeting Philipp

Please use plain text.
Mentor
madhukeshwart
Posts: 263
Registered: ‎03-18-2009

Re: map heating results of part insert to moldflow?

05-14-2014 09:14 AM in reply to: phammer
it is like for each element ...assign a value..!!
Madhukeshwar Talwar
FIAT-CHRYSLER ATC, Chennai
mail: madhukeshwart@gmail.com
09600060862
======================================
Please use . Accept as Solution and Give Kudos as appropriate to further enhance these forums. Thank you! .....
Please use plain text.