Community
Hello ,
I ran fill+pack+ warp analysis for an overmolded part . everything is ok up to Fill+ pack results but ones checking warp results it shows totally collapsed structure here i have included that result ...
why this is happen?
Hi,
from this result seen, I assume you run Autodesk Simulation Moldflow Insight 2013.
Please, have a look at this hotfix:
Autodesk Simulation Moldflow Insight 2013 Hotfix DL20323299
http://usa.autodesk.com/adsk/servlet/ps/dl/item?siteID=123112&id=20323299&linkID=13030538
Regards,
Berndt