Simulation Moldflow Insight

Reply
Active Member
FK1985
Posts: 9
Registered: ‎06-01-2011

Sink mark

549 Views, 1 Replies
06-07-2012 02:40 AM
Hi Dear, I would get technical support about Moldflow.We produce a part with two different material as ABS and ASA.You can find the basic dimensions of part which I mentioned on the attach. When I make sink mark analysis on moldflow, I can see sink marks about 0.0090mm-0.0195mm on analysis. According to my experiance; İf we see this values on moldflow,normally we can't notice the sink marks on real part.But we see sink marks. Is there any special values for ABS and ASA material for non noticeability on real parts? What do you think about our values(0.0090mm-0.0195mm)which we see on sink mark analysis?
Please use plain text.
Valued Contributor
biricio
Posts: 84
Registered: ‎04-25-2009

Re: Sink mark

08-02-2012 06:28 AM in reply to: FK1985

hi, it's very strange that you see sink marks in real model.

How are the results about Volumetric shrinkage?

 

Let's hear other voices.

 

Bye

Please use plain text.