Moldflow Insight Forum
Welcome to Autodesk’s Moldflow Insight Forums. Share your knowledge, ask questions, and explore popular Moldflow Insight topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Sink mark

1 REPLY 1
Reply
Message 1 of 2
FK1985
843 Views, 1 Reply

Sink mark

Hi Dear, I would get technical support about Moldflow.We produce a part with two different material as ABS and ASA.You can find the basic dimensions of part which I mentioned on the attach. When I make sink mark analysis on moldflow, I can see sink marks about 0.0090mm-0.0195mm on analysis. According to my experiance; İf we see this values on moldflow,normally we can't notice the sink marks on real part.But we see sink marks. Is there any special values for ABS and ASA material for non noticeability on real parts? What do you think about our values(0.0090mm-0.0195mm)which we see on sink mark analysis?
1 REPLY 1
Message 2 of 2
biricio
in reply to: FK1985

hi, it's very strange that you see sink marks in real model.

How are the results about Volumetric shrinkage?

 

Let's hear other voices.

 

Bye

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report