Moldflow Insight Forum
Welcome to Autodesk’s Moldflow Insight Forums. Share your knowledge, ask questions, and explore popular Moldflow Insight topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Problem! Mesh & wire sweep results.

0 REPLIES 0
Reply
Message 1 of 1
J_Liu
381 Views, 0 Replies

Problem! Mesh & wire sweep results.

Hallo,

as far as I know, once the mesh element size above a critical point,  the wire sweep or other results should have negligible difference. But in my simulations, the element size is already huge but the wire sweep results seem still not ideal.

From my results, I don't know which mesh GEL I should use for the further simulations.

 

Which mesh GEL has the higher accuracy in my case?? The wire sweep should be as small as possible but I don't think the smallest mesh GEL is a good choice.   It confused me and i cannot go further!

 

Here some results are enclosed. Thank you all very much!

 

Greetings from Munich,

Liu

0 REPLIES 0

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report