Discussion Groups

Simulation Moldflow Insight

Reply
New Member
quest_3001
Posts: 2
Registered: ‎01-01-2013

Moldflow insight 2013 finding mass

199 Views, 2 Replies
01-01-2013 02:12 PM

Is there any function where I can check the mass of the injected part at a specific area ? (after simulation with gas assisted)

 

Thank you

Please use plain text.
Mentor
madhukeshwart
Posts: 263
Registered: ‎03-18-2009

Re: Moldflow insight 2013 finding mass

01-09-2013 04:50 AM in reply to: quest_3001

yes, It is possible through log. In log mass will be availbe for part & feed system.

 

Regards,

Madhukeshwar Talwar

Madhukeshwar Talwar
FIAT-CHRYSLER ATC, Chennai
mail: madhukeshwart@gmail.com
09600060862
======================================
Please use . Accept as Solution and Give Kudos as appropriate to further enhance these forums. Thank you! .....
Please use plain text.
New Member
quest_3001
Posts: 2
Registered: ‎01-01-2013

Re: Moldflow insight 2013 finding mass

01-09-2013 05:50 AM in reply to: madhukeshwart

In the Log it tell the overall part mass but it does not relly say the specific area. In the attatchment file, I have simulate this part( part 3D and overflow ). In the log it tell me the "Part mass" and "overflow mass". For log  "part mass" it include part and the runner.

After simulation, how can I  select the specific area ( only the part not runner) to get the mass of the wanted part ?

 

Thank you

 

Please use plain text.