Infos searched: Constraints and loads

[p.hammer]

HI everybody,

I did two weeks in moldflow teaching but I still lack of many information.

Are there some Information how to use constraints and loads in the boundary condition tab.

I know how to use fixed constraints for core shift analysy.

But what is with pin, spring and general constraints. And how to use loads?

What information can I get out of using loads.

Greetings

[nordhb · Accepted solution]

Hi,
there is a module called Stress in Autodesk Simulation Moldflow Insight for structural analysis in Midplane mesh type.
You can run only Stress itself, or in conjuction with (Cool+) Fill+Pack (+Warp).
For Stress you can apply boundary conditions Constriants and Loads. You can also do this for Warp.
Note: for Midplane mesh type

Please, see Help:
ASMI Help >  User's Guide > Analysis sequence > Stress analysis >
for further information.
Or some fromwikihelp:
http://wikihelp.autodesk.com/Simulation_Moldflow/enu/2013/Help/Insight/2891-Analysis2891/3304-Stress... 

About constraints:
http://wikihelp.autodesk.com/Simulation_Moldflow/enu/2013/Help/Insight/2891-Analysis2891/3304-Stress...

About elemental loads:
http://wikihelp.autodesk.com/Simulation_Moldflow/enu/2013/Help/Insight/2891-Analysis2891/3304-Stress... 

Hope this helps.
Regards,
Berndt