Community
hello user!!
i have a one question, i suppose very easy, now a ran a fill + pack analysis on reactive molding, and i want review the air trap results, but i want see the results in opaque and closed by one circule (normally pink or red). my question is how can i cghange the display result? now i already changed from transparency to opaque, but i could not change the other thing.
Note: my analysis was done With 3D mesh.
regards.
Hi
Don't think it is possible as you wish...with an opaque Body you can't see defects which are shown inside
The rest would be Single Contour checked and Value 0.5
Regards,
Jay