2 Kudos
oren

Mesh size control in moldflow adivser

Status: New Idea
by oren on ‎01-17-2013 12:03 AM

This is something you need to have to enable the user to make more accurate analysis.

The parts I design are very small, the biggest is 40x9x9mm, most of them are much smaller.

The option to choose High Analysis Resolution is not good enough.

BTW all competitiors have the option to control mesh size for the basic modules, so you might loose your advantage since they are closing the gap very fast.

 

Oren T.

N-trig

Comments
by MichaelSchoo5437 on ‎02-12-2013 05:07 AM

Perhaps Insight would be a better answer to your problems?

Announcements
IdeaStation Guidelines
Review guidelines and best practices
before posting a new idea.