Community
Hello,
How is it possible to determine what gate diameter was used in a 3D analysis when the option for automatic gate size is selected?
Thanks in advance.
Bob
Hi,
the 3D mesh type and automatic gate contact diameter is based on mesh facet size around the injection location node.
To get an understanding on how derivated, you can have a look at:
http://wikihelp.autodesk.com/Simulation_Moldflow/enu/2013/Help/2.0Insight/0670-Modeling670/1115-Feed...
In Adviser you can use analysis sequence Runner Adviser on a runner system to get advice on dimensions.
Regards,
Berndt