Discussion Groups

Simulation Mechanical and Multiphysics

Reply
Active Contributor
tim.sefton
Posts: 31
Registered: ‎10-26-2011

Results Seem Off For Nozzle Analysis

126 Views, 1 Replies
12-01-2011 01:59 PM

Working on an analyis for a nozzel that uses an air amplification scheme.

 

The velocity magitude seems as though it is correct, but the flow rate through seems almost negative.

 

See pictures below - any thoughts are welcome.

 

Timlrgrad02.png

 

 

Please use plain text.
Employee
Joey.X
Posts: 259
Registered: ‎06-14-2010

Re: Results Seem Off For Nozzle Analysis

12-02-2011 06:43 AM in reply to: tim.sefton

Just a remind the tips at inquiring flow rate in POST processor

- Change result to flow rate  

- Select interested surface(s) only  or face(s) at interested elements

  (Never select nodes)

- Make sure result smooth is disabled

 

BTW, the negative flow rate is probably correct depending the inflow or outflow at selected surface(s).

Jianhui Xie, Ph.D
Principal Engineer
MFG-Digital Simulation
Please use plain text.