Discussion Groups

Simulation Mechanical and Multiphysics

Reply
Contributor
Posts: 11
Registered: ‎04-10-2012

Report Updating

85 Views, 2 Replies
04-16-2012 08:51 AM

Hello, everyone

I created and analyzed a model in Algor several days ago. Today, I made some changes to the boundary condistions and meshing settings as well. After running the analysis, I went to check the report. However, it shows the create date of model is several days ago, which should be quite different from the current model. I am wondering is the results automatically updated? Can I trust the results provided in the report, which is clearly showing a wrong date of create date?

Please use plain text.
Valued Contributor
dharhay
Posts: 52
Registered: ‎04-11-2008

Re: Report Updating

04-17-2012 10:15 AM in reply to: Lonelytown

I dont know the answer to your question.  However, the report function has never suited my needs or the needs of who may read a report. I have Word document templates that I edit for some important results and jpg files.  I find that I can do a reasonable job in a short amount of time and not be frustrated by the report functions quirks.

Dave H
Please use plain text.
Employee
Posts: 158
Registered: ‎11-12-2009

Re: Report Updating

04-17-2012 04:23 PM in reply to: Lonelytown

The first time the "Report" tab is accessed for a model, all the information is gathered and listed in the report.  Each time one visits the report thereafter, that original data is displayed, unless one right-clicks on "HTML Report" in the model tree for the current design scenario and selects "Refresh Report".  At this time, all previously gathered data will be replaced.

Pat Tessaro, P.E.
Customer Support Engineer

Autodesk, Inc.
285 Kappa Drive
Suite 250
Pittsburgh, PA 15238
Please use plain text.