Hi,
I'm doing MES analysis in Multiphysics 2013 and during the analysis an error message appears and analysis stops.
The message is "error opening in output files"
Can someone explain this?
What I got is as follows:
** Warning: element 3091 in part 7: determinant =-.86603495E-06<= DETTOL!
2.77848564E-03 3.5424 4.0000E-11 8 0 5.0000E-03
2.77848564E-03 3.5424 4.0000E-11 8 1 5.0000E-03c
2.77848568E-03 3.5424 4.0000E-11 8 0 5.0000E-03
2.77848568E-03 3.5424 4.0000E-11 8 1 5.0000E-03c
2.77848572E-03 3.5424 4.0000E-11 8 0 5.0000E-03
2.77848572E-03 3.5424 4.0000E-11 8 1 5.0000E-03c
2.77848576E-03 3.5424 4.0000E-11 8 0 5.0000E-03
2.77848576E-03 3.5424 4.0000E-11 8 1 5.0000E-03c
** Warning: element 3091 in part 7: determinant =-.10045208E-07<= DETTOL!
** Stop: too many time steps in autotm.
It is possible caused by:
Step reduction factor is too big
Why didn't you say it yesterday
Yesterday i reduced it and the analysis goes very fast. But it still doesn't finish. The analysis worked about 26 hours and suddenly the electric gone 😞 My ups worked 15 minutes and then the computer went to sleep mode but the anaysis aborted.