Discussion Groups

Simulation Mechanical and Multiphysics

Reply
Active Contributor
nosborne
Posts: 30
Registered: ‎12-19-2011
Accepted Solution

Contact with 2D Models

215 Views, 1 Replies
01-03-2013 12:02 PM

Can contact be modelled in Simulation between 2D edges on a 2D model? I have some gears that could be modelled with 2D elements but I don't know how to define the contact easily. If necessary I will use a 3D brick element model with a unit depth to generate contact surfaces. The attached image shows the contact interface (this is a crude gear model) that I want to model. If anybody has experience with this (good or bad) I would be happy to hear about it.

Thanks

Please use plain text.
Valued Mentor
AstroJohnPE
Posts: 498
Registered: ‎08-30-2012

Re: Contact with 2D Models

01-05-2013 09:15 AM in reply to: nosborne

Hello,

 

Contact on 2D elements is setup in the same manner as with brick elements. Use surface selection to pick the surfaces that will contact, right-click > Contact > Surface. (I presume you are using MES to account for the motion.)

 

Think of the model as if the 2D elements were extruded (in the X direction). When the edge of the 2D mesh is on different surface number than the rest of the mesh, the "extruded" surface number creates a face which can contact another object.

 

 

John Holtz, PE
Mechanical Engineer
Pittsburgh, PA

16 years experience with Simulation Mechanical
Please use plain text.