Robot Structural Analysis

## Robot Structural Analysis

Valued Contributor
Posts: 81
Registered: ‎11-16-2011
Message 1 of 6 (255 Views)

# which mesh size to obtain correct results reducing moments above supports?

255 Views, 5 Replies
10-24-2013 07:28 AM

Did some models, mesh was with a size of

1. 1/2 of coloumn width

2. same as coloumn width

3. 1,5 of a coloumn width.

All models gives defferent results. Which one i can pick for correct results?

Valued Mentor
Posts: 606
Registered: ‎09-07-2011
Message 2 of 6 (240 Views)

# Re: which mesh size to obtain correct results reducing moments above supports?

10-24-2013 04:17 PM in reply to: ilja.jevglevski

This is an engineering judgement and not really Robot related?

But, the accuracy of the result obviously increases with finer mesh.  It's a balance between accuracy and calculation time.

Distinguished Contributor
Posts: 132
Registered: ‎12-14-2012
Message 3 of 6 (199 Views)

# Re: which mesh size to obtain correct results reducing moments above supports?

10-29-2013 06:34 AM in reply to: tony.ridley

"You can also define an realistic area for the support -> avoid peaks of moment.

Go into the nodes properties"

But actually it doesn'st take into account the dimensions of the support in the results .. maybe it is only in the RC design modules ..

You will have to follow tony's instructions ...

Product Support
Posts: 3,619
Registered: ‎12-17-2010
Message 4 of 6 (185 Views)

# Re: which mesh size to obtain correct results reducing moments above supports?

10-29-2013 07:24 AM in reply to: t.sautier

But actually it doesn'st take into account the dimensions of the support in the results ..

Artur Kosakowski
Valued Contributor
Posts: 81
Registered: ‎11-16-2011
Message 5 of 6 (146 Views)

# Re: which mesh size to obtain correct results reducing moments above supports?

10-30-2013 02:27 AM in reply to: tony.ridley

Tony, if we look to slab span moments than it is. For supports it doesnt work. The smallest mesh is, the closest results you will get. For example, if you have support column 0,5x0,5m and mesh size 0,1x0,1 you will get very close results after "reducing moments above supports" to the peak ones. But for the reinforsment calculation they are too big.

Distinguished Contributor
Posts: 132
Registered: ‎12-14-2012
Message 6 of 6 (105 Views)

# Re: which mesh size to obtain correct results reducing moments above supports?

10-31-2013 10:18 AM in reply to: Artur.Kosakowski
Thx, forgot that!

Recently Solved