Discussion Groups

Robot Structural Analysis

Reply
Contributor
ovedmata
Posts: 17
Registered: ‎11-02-2011

slab connecting to wall approach, help....

277 Views, 1 Replies
12-08-2011 08:03 PM

so im connecting the slab to the circular wall, so I declared an opening to the slab which is a copied geometry of the wall opening at a lower level. However, If I don't add a fixed connection to the slab the way it shows then it gives me an execution and error and also won't analyse the wall panel when running slab/shell calculations.

 

Any ideas?

 

Thanks

 

Ivan

 

Please use plain text.
Product Support
Artur.Kosakowski
Posts: 4,595
Registered: ‎12-17-2010

Re: slab connecting to wall approach, help....

12-08-2011 11:59 PM in reply to: ovedmata

Ivan,

 

The goal is to connect the nodes of the cylinder with nodes of the slab located at the edge of the opening. The easiest is to define the contour of the opening and the circle that you want to extrude into a cylinder in the same way (the same center and the same number of divisions).

 

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.



Artur Kosakowski
Please use plain text.