Community
Hello,
Is there any facility in robot that we can display the punching shear capacity ratio similar to the attached file?This is very useful in the design of mat/flat slab.
Regards,
This information is available in the table and the calculation note but not displayed directly on the viewer where the locations with ration above 1 are shown in red (see: http://forums.autodesk.com/autodesk/attachments/autodesk/351/11165/2/2.JPG)
I have added this request to the wish list.
If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.