Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

manual load combination factors - load types - load nature

1 REPLY 1
SOLVED
Reply
Message 1 of 2
memoalcr
851 Views, 1 Reply

manual load combination factors - load types - load nature

If I define a load combination

LIVE=(LL1 + LL2) 

and in load types I assign "live" nature to it; when I try to manualy create a combination, say

COMB1 = 1.6 LIVE

and the load factor for "live" is set to 1.6 in the load factor table; ifI select LIVE from the "case list" column and transfer it to "List of cases in combination" column; RSA assigns a factor of 1.0 instead of a 1.6.

Seems to me that RSA does not recognize the nature of the load combination LIVE.

How do I assign the "live" nature to a combination?

1 REPLY 1
Message 2 of 2
Artur.Kosakowski
in reply to: memoalcr

This should not happen unless you define SLS combination type rather than ULS (1.0 is the default factor for SLS combinations for all loads). I indicated the steps for EC regulation on the attached picture. Mind taht at any moment you can overwrite the default load factor with the 'needed' one.

 

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

 

 



Artur Kosakowski

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report