Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

can't add thermal loads

2 REPLIES 2
Reply
Message 1 of 3
AJA14
1294 Views, 2 Replies

can't add thermal loads

I am trying to add thermal loads for bar elements. The problem is I can't find temperature or thermal loads in the new load type dialog. I've done it before but this time I can't locate it. If I open the load table and use the cell list, I can locate thermal loads. I even tried switching to different design and loading codes. Nothing happened. Any ideas.

Ali Al-Hammoud
Structural Design Engineer
MZ & Partners Engineering Consultancy
2 REPLIES 2
Message 2 of 3
Artur.Kosakowski
in reply to: AJA14

I'd say you look at the wrong dialog Smiley Happy 

 

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.



Artur Kosakowski
Message 3 of 3
Rafal.Gaweda
in reply to: AJA14

Hi,

 

Natures displayed there are taken from Code Combinations settings (active code).

Go to Job Preferences, check Code Combinations

codecomb.jpg



Rafal Gaweda

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report